1- If the cutter cannot find/read registration marks click on "Test" this will allow you to move the carriage so you can readjust the camera position
2- Once you have moved the camera over the registration mark press "Enter" the cutter will attempted to read the dots again
3- If the camera cannot read registration marks the camera needs to be recalibrated
4- To recalibrate the cutter, you will need to connect the cutter to a laptop or PC via USB
5- Load Transfer Print with registration marks on the flat bed cutter
6- Turn vacuum on to ensure the transfer is laid flat
7- Connect USB cable to Cutter
8- Open installed folder "WinTool"
9- Open "Device Manager"
10- Click 'Port Setting" right click "Properties and change Bit to 56700 click "OK"
11- Right click "WinTool" click on "Run as Administrator"
12- Click "Debug" and change Baudrate to 56700
13- Click "Connect To Device"
14- Use the arrows keys on the control panel to move head carriage to blank area on film
15- Click "Auto Exposure" and "Auto Threshold" turn on "Misc Light" Click "Save Settings"
16- Under "Get File" click both "Raw" and "Bin"
17- Click "Start" for camera to scan blank area of film for background calibration
18- Bin Previews shows the scanned and processed images of background
19- Click "Update Background" software tool will apply adequate settings automatically
20- Click "Save Settings" then click "OK"
21- Click "Start" again to see result after calibration
22- When camera is probably calibrated for background "Bin" will show black background without any noise
23- Calibrating for registration marks
24- Use arrow key to move head carriage
25- Position camera to be on top of registration marks
26- Click "Manual Exposure" and "Manual Threshold"
27- Set "Manual Exposure" to 10ms and "Manual Threshold" to 80%
28- Click "OK" and "Save Settings"
29- Click "Start"
30- Move Head Carraige until scanned image shows registration marks in the center and click "Start" to check
31- Showing clear circle shape with great contrast in black and white indicated camera is calibrated properly
32- Set "Segma X" to 0.75757 and "Segma Y" to 0
33- Click "OK" and "Save Settings" then click "Start"
34- Disconnect USB cable and close Wintool software
35- Cutter should be properly calibrated