Welcome to this tutorial on adjusting camera parameters for your cutter.
Install driver: Download and install the appropriate driver. Double-click the installation file and follow the on-screen instructions.
Connect devices: Connect the RS232 cable from your cutter to your computer. Make sure both devices are powered on.
Open software: Launch the WinTool software from your desktop or start menu. Configure connection: Select the correct RS232 port number and Baudrate in the software. Verify that the software and machine are communicating.
Automatic calibration: Place a blank film under the camera. Click on automatic parameters and update the background.
Manual adjustment: Place the printed registration mark under the camera. Switch to manual parameters and adjust values until a standard circle appears in the second window. The rounder the circle, the better.
Set specific values: Change the X value to 0.75757 and the Y value to 0. Save these parameters.
Reconnect: Disconnect the cable and plug the blue connector back into the machine. Power on to retest.
Test: Run a test job to verify accurate cutting.
Your camera parameters are now properly adjusted for precision cutting. Thank you for watching.